MR28 Installation Guide - Cisco Meraki

Introduction

Welcome to the MR28 Installation Guide page by Integrity Hotel Partners. Here, you will find a comprehensive guide on how to install the Cisco Meraki MR28 access point. Our detailed step-by-step instructions, along with helpful tips and best practices, will help you successfully set up your wireless network.

Preparation

Before you begin the installation process, it is important to gather all the necessary tools and equipment. Here is a checklist:

• Cisco Meraki MR28 access point - Make sure you have the device ready for installation.
• Ethernet cable - You will need an Ethernet cable to connect the access point to your network.
• Power adapter - Ensure you have the appropriate power adapter for the MR28.
• Mounting kit - If you plan to mount the access point on a wall or ceiling, make sure you have the necessary mounting kit.
• Network configuration details - Prepare your network SSID and security settings.

Step-by-Step Installation Guide

Step 1: Preparing the Access Point

Start by unpacking the Cisco Meraki MR28 access point and inspecting it for any physical damage. Once confirmed, follow these steps:

1. Connect the Ethernet cable - Plug one end of the Ethernet cable into the access point's Ethernet port.
2. Connect the power adapter - Plug the power adapter into the power port on the access point.
3. Power on the access point - Connect the power adapter to a power outlet and turn on the access point.

Step 2: Network Configuration

Configuring your network settings correctly is essential for optimal performance. Follow these steps:

1. Access the Meraki dashboard - Open a web browser and navigate to the Meraki dashboard login page.
2. Sign in to your account - Enter your login credentials and click on the login button.
3. Select the network - Choose the network where you want to add the MR28 access point.
4. Add the access point - Click on the "Add devices" button and select "MR28" from the list of available devices.
5. Configure wireless settings - Set up your SSID, security mode, and passphrase according to your network requirements.
6. Apply changes - Save your network configuration settings and apply the changes.

Step 3: Mounting the Access Point

If you plan to mount the MR28 on a wall or ceiling, follow these instructions:

1. Choose the installation location - Select a suitable location that provides optimal coverage and stability.
2. Mark the mounting holes - Position the mounting bracket against the wall or ceiling and mark the holes.
3. Drill the holes - Use a drill to create holes for mounting the bracket securely.
4. Attach the mounting bracket - Securely attach the mounting bracket to the wall or ceiling using screws.
5. Mount the access point - Slide the MR28 onto the mounting bracket until it locks into place.

Troubleshooting

In case you encounter any issues during the installation process, here are some common troubleshooting steps you can try:

• Check the network connections - Ensure all cables are properly connected and no loose connections exist.
• Reboot the access point - Power cycle the MR28 by turning it off and on again.
• Reset to factory defaults - If needed, you can reset the access point to its factory settings.
• Contact support - If the issues persist, reach out to our technical support team for further assistance.

Conclusion

Congratulations! You have successfully completed the installation of the Cisco Meraki MR28 access point. Enjoy seamless wireless connectivity and enhanced network performance with the MR28. Should you require any further assistance or have additional questions, do not hesitate to contact our dedicated support team.